Skip to main content

Replies sorted oldest to newest

Freight Train Jim posted:

If it is non powered it does not have motors or a board for control. Therefore you can't program it.  

Jim, even though it isn't powered it has an operating rear coil coupler and a rear LED.

Does it work correctly as Engine 1 then?

Maybe the Run/Program switch is installed backwards? Have you tried it in both directions?

I just worked on same vintage F-3s and had similar programming issues.  I swore I had some bad R4LCs.  I kept moving the B and dummy A boards up to the motorized A where I could hear the programming horn and they all worked then I put them back and they continued to work.  Based on that, just remove the radio board and reinstall.  Test it before putting the shell back on. 

Thinking back, I may have programmed each of the other R4LCs while in the powered A (to get the confirmatory HONK!!!) and then moved each one back to the respective shell.  Just make sure to use the respective engine number for each one. 

BTW, you could have left the strirrup steps on but.....live and learn by doing. 

Last edited by Steims
@Steims posted:

Since the B unit is programmable and addressable I believe the read switch provides an input to turn the reverse light on when the B unit is being pushed backwards.

I think that is done on the board.

At least his B unit didn't come with trucks like ours did having 3 normal wheels and 1 grooved wheel for a tire. 😱😱😱

The hall effect sensors Lionel uses are not sensitive to direction, so it would have no idea when to turn on a backup light.  Besides, the light is doubtless fed from the R4LC and command controlled.

It's interesting that the parts list does indeed specify one truck with the hall effect magnet.  I'm having difficulty with what they are using it for...

Attachments

Images (1)
  • mceclip0

Indeed it doesn't Marty, which is why I expressed curiosity as to what it could be used for.  However, having the sensor as part of the parts list at least suggests it was intended to be there, it's pretty unlikely that Lionel would put it there not to use it.  Obviously, the only way to know for sure is to be able to examine the engine and see where it's connected.

Add Reply

Post

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
Link copied to your clipboard.
×
×