ProtoCoupler Connection to newer Protosound power board

Replacing  Protosound boards in an F2A that has an original protosound board set, where the motor and power connectors are wires, not 2-pin molex connectors.  Question is this:  The protocoupler wire on the original installation goes from 'coil 1' on the board to the center position on the direction switch.

The new board has a four pin connector (see attached photo).  Pinouts are:  ACG, coil 1, ACG, coil 2.  My question is this - Can I connect one wire from 'coil 1' to the center of the direction switch?  or do the couplers operate in a different manner on the new board versus the original?

Bruce

IMG_6454

Original Post

Add Reply

Likes (0)
The DCS Forum is sponsored by


OGR Publishing, Inc. PO Box 218, Hilliard, OH 43026 330-757-3020
www.ogaugerr.com
×
×
×
×
×