Skip to main content

I recently Purchased the MTH DCS and Wifi and my other two engines added fine (one Diesel and another subway set). But My protosound 3 R32 subway set isn't adding. It worked when i used it in conventional mode and even did a factory reset on it. and it still wouldn't add and i made sure the switch was set to DCS.

 

the WIU is on version 1.1

TIU is on version 6.1 (latest version)

 

Is it possible to do a complete Factory reset from the DCS app?

 

Original Post

Replies sorted oldest to newest

Can you put it on a spare piece of track connected directly to the TIU and try again?

I have to ask, how is your track signal strength?

What exactly do you see when it's on the rails? Does it show any new address when you try adding to the app?

What version is your app? ( the free basic one?) You can only have 3 total engines on that app.

The board maybe scrambled and the reset that you did may not have cured it. Can you take it to anyone with a remote?

I'm not a tech and I'm just throwing out what maybe happening.

You can't reset it if it's not in the app yet.

Is there an recover engine feature listed in the app? (I have to go see)

Last edited by Engineer-Joe

Add Reply

Post
The DCS Forum is sponsored by

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
Link copied to your clipboard.
×
×