Skip to main content

I recently acquired an older set of MTH F-3' with a 8.4 volt battery.  The battery that came it it was way past dead. The locomotives have never seen the track until today.  I charged the new battery for about three hours and then ran it with speed control on it ran great and the sounds were excellent.  I do not have DCS so I turned speed control off with the one horn two bell combo.  The sound immediately went down.  It ran perfect with plenty of speed and pulling power.  I have never owned a PS 2 8.4 volt locomotive before.  Does anyone know if this is common for these locomotive to do this.  This is a beautiful set of locomotives that I would hate to have to replace the PS 2.0 boards with PS 3.0.

Original Post

Add Reply

Post
The DCS Forum is sponsored by

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
Link copied to your clipboard.
×
×