Skip to main content

Still have several 5V engines; curious as to what are the most common causes of failure; if derailments or track shorts, can one use a poly switch on the power feeds to the board to protect it?  Basically trying to keep these locos operable until they commit suicide; thanks for the help; Falcon70

Original Post

Replies sorted oldest to newest

It's somewhat of a mystery, I have some that have stood the test of time, and others that ran, and a few weeks later were DOA.  I know that I've seen a number where capacitors failed, but lots of other failures as well.  Many people report storing them away working, and when they are unpacked again, they are either simply dead, or they present a direct short across the track.

A poly switch is way too slow to protect against stuff like power surges, however a TVS right in the locomotive is a good idea if you're already in there fixing things. 

1500W 33.3V TVS at Digikey

Another thing to do is make sure the battery is good and charged before starting up if they've been stored for some period of time.

John, do you know when or what the Premier model numbers are  that MTH went to the PS2  3 volt boards?  I’m looking at buying a 20-2399-1.  MTH shows a delivery date of Dec. 2002.  I have only one PS2 engine that has the 5volt boards.  It was dead in the water when I got it.  I sent GGG the boards, which he repaired and sent them back to me.  It’s been working fine since.  I put the double cap bcr in it with the zener diode.

 

Larry

Not difficult at all, the PS32 board with 5V connectors is again in stock at MTH.  You simply have to remove the old 5V board, secure the new PS32 board, and plug in the connectors.  One change is the speaker, you have to replace the old 16 ohm speaker with a 4 ohm speaker.  The PS32 board is currently only available to ASC's, but you can obviously buy one from one of them if you need one.

The only fly in the ointment is occasionally the space available and the length of the harnesses in some diesels require some modification for the board to fit.  Other models like the P5 or Bi-Polar are a very tight fit for the PS32 board and do require more work.

For that GP30, it looks like it would be a reasonably straight-forward fit, other than perhaps adjusting a harness or two.  Since the big fat battery is no longer there, I think the board should fit.  It could be close, the PS32 board is slightly longer...

FWIW, run the 5V board until it croaks.  Some of them run for a long time.

Attachments

Images (1)
  • mceclip0
Last edited by gunrunnerjohn

Add Reply

Post
The DCS Forum is sponsored by

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
Link copied to your clipboard.
×
×