Skip to main content

A friend is having a problem with a PS2 engine which was working fine until recently. It has a 3 volt board. When placed on the track and 18 volts are applied, there is a click from the relay on the PS2 board and then a few seconds later the relay starts to chatter.  I charged the battery overnight which made no difference. I also checked the engine over for any loose connectors and pinched wires. Everything looks OK. 3 rail/2 rail switch is in the 3 rail position, tried the DCS polarity switch in both position but that didn't make any difference. The engine will not add to the remote, message says "no engine to add".

I tried it in conventional and had the same symptoms with the relay chattering.

Any suggestions as to what may be wrong would be appreciated. I'm afraid there is a problem with the PS2 board itself.

 

Ken

Original Post

Replies sorted oldest to newest

Add Reply

Post
The DCS Forum is sponsored by

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
Link copied to your clipboard.
×
×