Skip to main content

Installed a PS3/2 board set into a Premier GP-40 (20-2425-1).  All wiring is connected, no pinched wires.  Tested the installation in conventional mode after the shell was installed and everything worked fine.  Lights, sounds, horn, bell, couplers worked fine.  Used the Technician service loader to upload the ps3 file and flash.  Running in either DCS or conventional now and the rear headlight and interior lights do not come on.  Tried feature reset - no change.

Any ideas?

Bruce

Original Post

Replies sorted oldest to newest

Lou1985 posted:

PS3 flash code = PS3 upgrade kit

PS32 flash code = PS32 board

Put the PS32 flash code in and report back.

While true, some may be confused because the PS-3 Steam upgrade is called PS-3 but is really a PS-32 board.  So you leave it alone too, unless odd engine requiring one of the other PS-32 steam flash codes.  G

Add Reply

Post
The DCS Forum is sponsored by

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
Link copied to your clipboard.
×
×