Skip to main content

Recently upgraded to DCS 4.2 and was able to add new BNSF Dash 8 to system. Slightly afterwards, I finished changing wheel sets to hi rail on second BNSF engine , set all switches to same locations on engine as on first engine. DCS can not find this engine,

 

I have left engine on track with power on , but no luck with capacitor, no sounds, no lights.

I tried tilting engine on side and putting it back on rails but that did not bring it up in Conventional either.  Any suggestions.

 

All the buttons were switched to other side to test for faulty wiring job, no good.

 

Remote is up to date, found engine BN 844 , will not find BN 878 ,

Original Post

Replies sorted oldest to newest

Yep, Finally, I moved TIU back to the train layout and was eventually able to load engine 878 into DCS. It went in as #9.  I was able to then change number to 90 and then was able to create lash-up at 91.  Now I have to find a solution to channel 3.
Blown fuse.
 
#844 is at 89, 878 is at 90 and lash up is at 91.  All running fine.
 
Thank you everyone for your suggestions and patience.
Post
The DCS Forum is sponsored by

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
Link copied to your clipboard.
×
×