Skip to main content

@DL&W Pete posted:

Gunrunnerjohn, 

Can you still get a ps3 kit for steam with smoke unit. I have a Weaver Models Pacific that I might want it installed in. I want the straight diesel tether from the tender to the engine.

Yep, I buy the smoke units separately, obviously they don't come in the kit.  Is this a brass steamer or diecast?  The straight tether is really dependent on how much clearance I have, some lend themselves to it better than others.  Also, typically the straight tether limits the type of curves, so if you have wide curves, you'll be happier with the operation.

Yep, I buy the smoke units separately, obviously they don't come in the kit.  Is this a brass steamer or diecast?  The straight tether is really dependent on how much clearance I have, some lend themselves to it better than others.  Also, typically the straight tether limits the type of curves, so if you have wide curves, you'll be happier with the operation.

It is die cast, this was the run that was for K-line but they went under. So Weaver took the order.

 

I have had the slave board go out 2-3 times so I’m looking for either a reliable fix or an upgrade to replace or eliminate it. The last time it went out was a week ago, fortunately I had a spare which now needs to be repaired or replaced. With the money I have already spent repairing this unit I could have upgraded both A units. Harlee62

actually you can get ps 2 salve boards repaired so thy won't fail i have done it!

Alan

Last edited by Alan Mancus

Add Reply

Post
The DCS Forum is sponsored by

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
Link copied to your clipboard.
×
×