Skip to main content

Hi all,

I picked up a set the new MTH R-40 Proto 3 subway set. It came with a plug wired with an in-line resistor. There is no mention of it in the instruction manual, or did I miss something? Does anyone know what it is for? I run using DCS. Thank in advance for any and all information.

Best regards for a Happy, Healthy and Safe 2023!

Attachments

Images (3)
  • IMG_4175
  • IMG_4174
  • IMG_4173
Original Post

Replies sorted oldest to newest

Yes, the plug is intended for use if you replace the rear Proto-Coupler with one of the short fixed non-operating couplers.

Switching to the shorter couplers will bring the cars closer together for a more prototypical appearance. I think they look better that way but a potential drawback is that it increases the minimum curve required. My El has loops with GG O-42 and O-54 curves: the R40s will negotiate O-42 curves with the factory couplers but the pantograph gates will touch with the short couplers. The short couplers are fine on my O-54 or larger loops.

Add Reply

Post

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
Link copied to your clipboard.
×
×