Skip to main content

Hi To All,

Over the summer I was able to get a Lionel 364 Lumber loader for our Christmas Layout. After tearing it down to clean I noticed that the bracket on the motor that the tension spring post goes through had broken off the motor. The bracket is fine but I don't believe there is enough material  on the 3 posts on the motor that align the bracket to the motor to re pin them. Any ideals  would be welcome. Should I try an drill and tap the remaining 3 posts or try some JD weld. Regards dadroadie

Original Post

Replies sorted oldest to newest

It is a 364 conveyor loader, not the 164 log loader.
The referenced bracket uses three swedged "nubs" on the gearbox to hold the motor. Drilling into the gearbox/ bearing endplate (364M-11) needs to be done very carefully to avoid interference with the wormshaft and gearing. With this said, it is probably the best option for a secure connection.

Last edited by Überstationmeister

Add Reply

Post
OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
330-757-3020

www.ogaugerr.com
×
×
×
×
Link copied to your clipboard.
×
×