Skip to main content

Use barrier strips to connect your controller wires under the platform or control panel, and then use thermostat, security, station, or bell wire to extend from the barrier strip to the switch location(s). You really only need to run three wires out to the switch if you connect all of the GND wires together to a convenient common ground near the controllers.

Add Reply

Post
This forum is sponsored by Lionel, LLC

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
Link copied to your clipboard.
×
×