Skip to main content

Replies sorted oldest to newest

   Find a vertical "top dead center" on the wheel/rod boss, like a gasline motor's piston, mark that maximum height postion TDC#1, mark on the wheel o.d. ANYWHERE, and in align the other side to it's TDC#2 (a 90° easily arrived at being the maxium distance of movement left or right from the vertical reference I.e. just like verctical but measure sideways; Maximum iis the goal, not a certain number ). With TDC#2 mark aligned the mark for TDC#1 must still match up. You could substitute/add in some math too of course.

  I take it they aren't splined? With splines I always found it pretty easy. 

Add Reply

Post
This forum is sponsored by MTH Electric Trains

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
Link copied to your clipboard.
×
×