Skip to main content

While trying to detach the wires from the drum loader so that I could one of the fixes so that the drums will load reliably, the clip used to attached the wire from the power source snapped off. Any suggestions for the best way to repair or replace the clip would be appreciated.

Also, any suggested fixes for the erratic barrel loading not previously posted would be appreciated.

Thanks,

Rubin

Original Post

I'm not sure what the bottom of the drum loader looks like.   You could attach a wire as you would to the good clip.  Solder a wire to the broken clip.  Hot glue a terminal strip to the bottom of the accessory and connect wires to the screws on the terminal strip.  Now instead of the clips, you can use screws on the terminal strip.

Steve

Add Reply

Post
OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
330-757-3020

www.ogaugerr.com
×
×
×
×
Link copied to your clipboard.
×
×