Skip to main content

Replies sorted oldest to newest

Every once in a while, someone goes through the litany of K-Line reset sequences and revives conventional operation, I remember one here recently.  However, I no longer screw around with them if they flaky and a basic reset doesn't fix them, I just put in a real cruise board!

Here is the reset code for a Kline command engine with cruise.

Engine 99, then set, then eng 1 (or whatever you want you final
ID to be) then set; then Aux1; next, this is important, 7,8. The 7
tells it that it has cruise and the 8 is Lionel’s code for steam with
puffing smoke. A good check for you to see if you have cruise is
after you have done the reset I mentioned, turn track voltage off,
pull command base plug, now using the variable speed control,
speed up, and if it takes a period of time for it to start running,
and when it does move, it moves super slow, you have cruise; if
it takes off normally, you do not have cruise. This is where the 7
comes in. If the R2LC is not told it has cruise, it will not run in
non command. It will do everything but move.


To set speed steps with Kline cruise;

Press DIR, BELL, AUX1 then (#1) for 32 steps, (#2) for 128
steps, (#3) for 256 steps. 128 seems to be smoothest.

Add Reply

Post

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
Link copied to your clipboard.
×
×