Skip to main content

Ross Custom's 3-way switches are a pain to properly wire. but sometimes you have too little space for a 4-way.  I am not an electronics guy so for me wiring a 3-way using 4 diodes so that two DZ-2501 controllers controlling two DZ-2500C switch machines could properly align the rails in three spur directions was a real "trial and error" production.

As it happens, there are no wiring diagrams directly on point available from either Ross or DZ to wire a Ross Custom 3-way with DZ-2500s..

Anyway since I had wired the 3-Way for non-derailing as well I decided that if I just wired the three turnouts to three momentary switches ( to ground) I could use those to control the 3-way instead of the two DZ-2501s. However, there are no three-momentary switches that I could find ganged together so I designed and 3D printed one, a 3-switch.

Here are the three 3D parts to create the 3-switch; note the purple is a representation of the circuit board with the three momentary switches attached. The circuit board is just a "break-out" board where I could mount the 3 small momentary switches.

 

Assembled it looks like this, excuse the art-deco look:

 

As printed and  unpainted,  it is this:

 

The 3-switch is raised up to sit above  and between the two DZ-2501 switches on the control panel.

by pushing the "L "the Ross Custom 3-Way turnout sets to the left most spur; "C" center and "R" right-most spur.

Attachments

Images (3)
  • mceclip0
  • mceclip1
  • mceclip2
Original Post

Replies sorted oldest to newest

So why did I buy a 3D laser printer?;----> because I am old and getting older. My hand-eye coordination is slowly going downhill. I am not as good with a X-acto knife as I once was.  My ability to glue things in proper position is going as well.

Instead of giving up for the Ole Folks Home,  I replaced my slow- deteriorating abilities with a 3D drawing program and a 3D printer.

Now I can build whatever I can imagine or rather create with Rhino6 and a FormLabs 2.

FormLabs recently came out with ceramic resin. Cant wait to try that and use a Kiln to create ceramic objects that will never deform under intense heat and pressure, like used on the skin of the space shuttle.  Look out Buck Rodgers.

 

Thanks I will take a look at that. I downloaded ????? 360 (free version of some Autocad program), but have not tried it yet. Watched a video on it and they made it look so easy... I will look at Tinkercad first though, I used to use Autocad many years ago at work ('80s & DOS version) and it had a fair learning curve as I recall. I was a lot younger and learned a lot quicker back then too! 

Edit - (Fusion 360, went and looked it up).

Last edited by rtr12

Didn't know that either? Nice to know though. I took a quick look at the Tinkercad site earlier and put a link on my desktop for further study. I'll take a look at youtube as well, I think that is where I saw the video that made Fusion 360 look so easy.   Some old dogs definitely have trouble with the new tricks, at least in my case anyway. To butcher GRJ's tagline a bit here: It always looks extremely easy when watching someone else doing something!  

Add Reply

Post
The Track Planning and Layout Design Forum is sponsored by

AN OGR FORUM CHARTER SPONSOR

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
Link copied to your clipboard.
×
×