Skip to main content

I recently had to send back my legacy 990 in for warranty service. Received it back and set up to run my legacy engines and my old conventional engines. In setting up the loops I used the "TR" for each loop . I then set the TR in info to clear and yes as stated in the Powermaster manual. When i switched my Power master to Run and conventional I do not have control of track voltage trough the thumb wheel on the Cab 2 along with actually no forward/reverse and whistle etc. controls for my conventional engines. When I power up the track is at full power  all times. A & U terminals all connected correctly. also it did work properly before I sent it in to Lionel for service on the control system which what they fixed was not related to this issue. Did they possibly do some type of upgrade that I am not aware of.

Thanks In Advanced for your feedback

Original Post

Replies sorted oldest to newest

Add Reply

Post
OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
330-757-3020

www.ogaugerr.com
×
×
×
×
Link copied to your clipboard.
×
×