Skip to main content

Been running my Weaver 2-8-0, with no problem. This morning I introduced after a lenghty absent my 2 Legacy Sharknoses A-As to the layout. I suddenly noticed any changes I made to the 2-8-0, affected the Sharknose. Also when I blew the horn on the 2-8-0, the Sharknose would also go off. Or any changes to Sharknose, effected the 2-8-0.

What's wrong? Shutdown, get a cup of coffee and come back and try again. Same thing. Do a reset? Then it hit me. The 2-8-0 was engine #45. Even though whenever I made changes to the Sharknoses I used TR2 to control the Lashup, one of the Sharknoses was programmed as also #45.  Problem solved, changed it to #43. Wish all my problems were this easy to solve.

Original Post
I often forgot to take one engine out of a lashup.  Then would address a new lashup with the same TR number.  Of course the first engine would take off unexpectedly while addressing the new lashup.  This caused problems sometimes.  When removing an engine from a lashup, be sure to reprogram the engine to TR 0.

Add Reply

Post

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
Link copied to your clipboard.
×
×