Skip to main content

Replies sorted oldest to newest

In my area (South Jersey) 1/2" homosote is about $ 30 for a 4' x 8' sheet and carpet padding is anywhere from $ .49 to $ 1.09 a square foot. That works out to $16 to $32 for the same size depending on thickness.

So padding could cost half the cost of homosote. Maybe cheaper if you find a sale. The prices were from my local depot.

Sean

I got padding from a local carpet store in NC, 58 cents a square foot. no mess, no fuss. The padding sits upside down on the layout, makes it easier to work scenery and ground cover on. instead of screwing the track down, I use small dabs from a hot glue gun to hold down track....never had an issue. If I need to move a piece of track, I slide a razor blade across the glue joint so it don't tear up padding, then just peel the little remnant of glue off the ties......sometimes the silent operation is very therapeutic from the noises at work.....So I have put a ton of effort in run quiet....

I am using Fastrack, which is noisy.   I have tried a couple of ideas:  the ceiling tiles mentioned above works.  

I am currently using 2" foam board for my layout base, and cover it with Woodland Scenics grass mats, which have a rubbery-vinyl base.   Together, these cut down the noise dramatically.   I am happy with this technique, and will be using it on my next layout I am beginning.

I picked up 5 rolls of Blue Hawk Anti-Fatigue Mat P/N #0771831 at Lowes a few months ago, the mat is 3/8" thick x 36"x60".

That gives me 12 pieces of 3" wide strips to use as roadbed, each 5 feet long, so 5 rolls will give me 300 feet of roadbed, not bad and last time I added it up this was cheaper than the cork roadbed we usually see. It's easy to cut with a box cutter type blade and can be easily beveled in a bandsaw using a fence.

Reduces the noise level, but  IMO putting ballast down on just about anything will jack the noise up again.

There's other posts where I've mentioned this and provided some crappy photos.

 

Bob Delbridge posted:

I picked up 5 rolls of Blue Hawk Anti-Fatigue Mat P/N #0771831 at Lowes a few months ago, the mat is 3/8" thick x 36"x60".

That gives me 12 pieces of 3" wide strips to use as roadbed, each 5 feet long, so 5 rolls will give me 300 feet of roadbed, not bad and last time I added it up this was cheaper than the cork roadbed we usually see. It's easy to cut with a box cutter type blade and can be easily beveled in a bandsaw using a fence.

Reduces the noise level, but  IMO putting ballast down on just about anything will jack the noise up again.

There's other posts where I've mentioned this and provided some crappy photos.

 

Need to check this stuff out!!

Thanks,

Joe Gozzo

Add Reply

Post
The Track Planning and Layout Design Forum is sponsored by

AN OGR FORUM CHARTER SPONSOR

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
Link copied to your clipboard.
×
×