Skip to main content

Replies sorted oldest to newest

you should power the tracks with transformer only no tiu or tiu dcs turned off all off in menu! then see if engine will start up in conventional . engine should at least startup with track power applied 10 volts or higher, sounds should come on and if you hit red direction button  engine should start to move, if not  you could have a wiring or board issue ! If engine runs ok do a conventional reset and try to run engine again with DCS! one Bell and % whistle and you should here 2 whistle toots to let you know it reset! then try dcs again! PS an engine item number would help so we know exact board you have ps 2 5 volt ps 2 3 volt etc. !!

Alan

Last edited by Alan Mancus

I made a discovery.  Track power and TIU on.  Next I unplugged the power cord and the USB cord from the wifi unit. Replaced the USB and the power and pressed the WPS button for a few seconds.  Waited until the power light and TIU light were steady and the wifi light blinking.  Picked up the android phone and moved an engine from inactive to active and started it up.  Success.  Just to be sure I did the same for another MTH DCS engine.  What to think?  Does the wifi unit have mind of its own?

Add Reply

Post
This forum is sponsored by MTH Electric Trains
OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
330-757-3020

www.ogaugerr.com
×
×
×
×
Link copied to your clipboard.
×
×