Skip to main content

I know I can buy them but I wanted to try and build myown.  I know that stairs come in many different shapes and sizes but what dimensions do I need to have for a set of "1/48 scale" steps going into the mobile trailer I'm building. I tried using 11" deep and 7" tall but I got some good awful fraction.    Nothing to fancy just how tall and deep they need to be.  Thanks for all the help I have received in the past from everyone.

Original Post

Replies sorted oldest to newest

I have been doing industrial "stairs" for the last 46 years as a structural draftsman. 

Today, Industry standard as well as a lot of building codes goes by the "7-11" rule.

Back in the day, we had another rule we went with. The height of (2) risers plus the width of the tread had to "fall" within 24" to 25". This allowed for various heights of risers and tread combinations. For instance, (2) 6.5" risers and (1) 11" tread equals 24".

I have seen risers as short as 6" and as tall as 8.5" in the industry. Once you get over that height of tread, the stair becomes a "ship ladder" type and then there are all sorts of options. Remember, the maximum height between landings for a tall stair should be 12'-0". 

For our 1:48 scale layouts, I would just go with what looks good. I doubt OSHA will be visiting your layout to look for compliance!  

Hope that helps.

Donald

Way back in the day in commercial construction we used "rise 7, run 12". But in stepping for trains and things I tried to use whatever looked right.  In the photo below I had to fudge up a tad on "rise" and skimp on "run" to finally reach (behind gate) the high entrance to Ramsford Palace,then if it looked a little off I covered it with snow.

Foam steps.

 

 

IMG_2099

 

Attachments

Images (1)
  • IMG_2099
Last edited by Dewey Trogdon

Up close, follow scale. Distance, whatever looks good........................

 

PRR GLA MTH ebay 18 [13)

  Station steps like these were made in 1932. Steps were many and also short due to the high rise up to street level as with subways as well. Many things to consider in proper era modeling.

Attachments

Images (1)
  • PRR GLA MTH ebay 18 (13)
Last edited by SIRT
Trainman2001 posted:

Just measured my steps. Height of tread 7.5". Length of tread 10.5". I bought Rusty Stumps laser cut stair kit to use in scratch building.

I have done a couple of sets of stairs 1:1, using very nice 2" X 12" lumber for the stringer. Rise/Run layout usually requires some head scratching.  The idea is to get all the rises equal, combined run usually has to fit a certain space.  

Rusty Stumps

Last edited by Mike CT

Add Reply

Post

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
Link copied to your clipboard.
×
×