Skip to main content

Happy Sunday.

Here is a picture of a section of my Pennsy Block retaining walls. A friend has a mold so I cast some out of plaster, I got tired of the typical Grey and went for another color. The plaster when thoroughly dried were stained with a watered down Woodland Scenics Burnt Umber. After the stain dried I took some hard pastels chalk and scraper off some black and Dark Brown then worked it on with a "DRY" brush.  Last I sealed each section with Dullcote.  What colors are your retaining walls?

 

BTW the 2-8-Consolidation was weathered by Harry Hieke

 

Lets see what you have this week

Steve

5-29 014

Attachments

Images (1)
  • 5-29 014
Last edited by L.I.TRAIN
Original Post

Replies sorted oldest to newest

 I work as a school bus mechanic. Often times you tap the exhaust pipes with a hammer to see how thick they still are and search for any small holes. The old steel you hammer. Hits the ground in small pieces that are perfect for rusty old steel sheets that looks like they have been cut with a torch. I started by taking a new Weaver gondola out of the box. A few measurements and some foam was cut and carved to fit in the body. A good thick coat of black paint, a liberal dosing off fine cinders and I set it out to dry. I then applied a thick adhesive to secure the metal pieces. A black and brown wash to fill in the crevices, a little chalk, some dry rushed artists paint, followed by some flat clear spray. I gave the car a quick weathering job and Kadee's. Total time on this project was under an hour. Often times I do these when running trains or another project as it takes some drying time throughout the steps.

 

image

image

Attachments

Images (2)
  • image
  • image
Originally Posted by Dave_C:

 I work as a school bus mechanic. Often times you tap the exhaust pipes with a hammer to see how thick they still are and search for any small holes. The old steel you hammer. Hits the ground in small pieces that are perfect for rusty old steel sheets that looks like they have been cut with a torch. I started by taking a new Weaver gondola out of the box. A few measurements and some foam was cut and carved to fit in the body. A good thick coat of black paint, a liberal dosing off fine cinders and I set it out to dry. I then applied a thick adhesive to secure the metal pieces. A black and brown wash to fill in the crevices, a little chalk, some dry rushed artists paint, followed by some flat clear spray. I gave the car a quick weathering job and Kadee's. Total time on this project was under an hour. Often times I do these when running trains or another project as it takes some drying time throughout the steps.

 

 

 

Very nice scrap metal load. That is an excellent source of metal.

Don

Originally Posted by L.I.TRAIN:

Dave and Don,

Nice loads on those Gondolas. And Weaver made a heck of a Gondola to bad they went out.

Steve

They were very nice gondolas. Another forum I belong to did a six car set in B&A livery. They may rise again under the new ownership, but it may take a while.

Don

Add Reply

Post

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
Link copied to your clipboard.
×
×