Skip to main content

Replies sorted oldest to newest

@Doug Bo posted:

There is no rev indication on the bottom of the TIU ( so it must be Rev G) My remote is running 6.1 but does not see TIU. I figure the TIU needs to be replaced.

   Thanks

Doug, Barry Broskowitz mentioned this rare problem a number of years ago.  You may not need a new TIU and to pay the moronic prices people are charging for them.  This may, or may not, work but it costs $0 while a new or used TIU might be $600-$800.

If your remote is 6.1 then your TIU is likely 6.1 as well.  You will not need to reload the remote but the TIU will need to be reloaded.    Reloading will set the TIU to #1, if you only have one this is not an issue otherwise you will need to reset the TIU number to whatever it was previously.

Last edited by Danr
@MartyE posted:

The 9 blinks is an indication of a failure of the microprocessor or memory.  There is no fix for this if the software reload doesn't work except a trip to MTH Serrrrrv,  never mind.  I would look for a a REV G as well if the software load isn't helpful.

True enough, Marty, no warranty implied but at $0 it is worth a shot.  After that it is an MTH tech, wait for the WTIU or pay a gangster the ridiculous price on eBay.

Add Reply

Post
This forum is sponsored by MTH Electric Trains

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
Link copied to your clipboard.
×
×