Skip to main content

hey all I just got my first TMCC engines 2 altas O. I’m trying to run them with the DCS sense I don’t have the Cab 1 throttle but I do have the trainmaster bass and all the right hook up wires. My problem is I tried the #1 engine address like the book saids but the engines won’t do anything other then the engines lights are on and the speaker just hums. I have no idea what number the TMCC engines are programmed to sense but it’s not #1 so my question is can you Reset these back to Factory using the DCS remote sense I don’t have the Cab 1 thanks for any info! 

Original Post

Jesse,

Just use DCS to change the engine's TMCC addressee to what you want it to be. With teh engine sitting on a powered track:

  • Menu/System/Engine Setup/Edit Engine/Edit Engine Address
  • Follow the prompts to set the RUN/PROG switch to PROG
  • Select a new TMCC engine ID#
  • Follow the prompts to set the RUN/PROG switch to RUN

That will set the engine's TMCC address to what you want it to be. Then, see if the problem persists.


DCS Book CoverThis and a whole lot more about DCS is all in MTH’s “The DCS Companion 3rd Edition!"

This book is available from many fine OGR advertisers and forum sponsors, or as an eBook or a printed book at MTH's web store!

Add Reply

Post

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
Link copied to your clipboard.
×
×