Skip to main content

Hey all, I have an odd TMCC issue. I have 2 TMCC engines that run from my Legacy controller just fine. When I try to run them from a CAB 1 TMCC box and remote, everything works (horn, bell, direction, etc) except the throttle. Nothing happens. Either engine. The Boost produces very slow movement. I have tried resetting the stall, re-programmed the engine, no change. Hook the Legacy back up, away it goes. But the really odd thing is that I have 2 Cab 1 remotes that do the same thing. Neither will respond to the throttle increase. Both remotes cant have the same hardware issue can they? They are 2006 or so vintage.. Thanks

Original Post

Replies sorted oldest to newest

It could be that the momentum on your Y6b is set to medium or high.  Open the little door at the bottom of the Cab-1, address your locomotive and press the "L" button (for Low momentum).  Throttle response should now be normal.  The locomotive will remember this momentum setting until you change it.

Add Reply

Post

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
Link copied to your clipboard.
×
×