Skip to main content

I would like some help please again

This time on track

My question is how do you tell if a track is bad I I have a short I think on a piece of track the locomotive will be going just fine then when the locomotive comes around a corner or some times when the train goes. Over  a track switch  the locomotive will stop and  go the opposite derection is a short on the track ? How do. I tell if a piece of track bad or not ?

Thank you for your time

Original Post

Replies sorted oldest to newest

Were it a "short" in a section of track it would short out the entire block and trip the circuit breaker in the transformer. The engine is losing power traversing the turnout. If it reverses rather than going into neutral then the engine has a two position reverse unit. As they asked, what engine and what kind of track?

Don,

You have to make sure that the curved track section, and all of the screw holes in the switcher, have screws in them that are really screwed down tight.   I had a similar problem, and found that since everything was not screwed down tight, the track and switch had occasional "high spots" in the rails, which caused the opposite side of the  loco to lift up off of a rail, which can cause it for a split second to lose power.  This can also happen if one of the rails in track section got slightly twisted out of shape, due to someone having to really pull hard or twist to yank an old pin out of the end.

I would start by throwing away the track sections where the problem occurs, and install new or nearly new track there.  Then start screwing things down.  Also make sure you install brand new pins and crimp them down hard with a proper track crimping plier.

Maybe this info will help.

Mannyrock

Add Reply

Post

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
Link copied to your clipboard.
×
×