Quick question here. I there any problem running some of my power feeds to the connecting electrical bars on the underside of Ross Ready Switches. I am poor at soldering to the rails so far and I am thinking this may help make some of my job easier. I know I will still have to solder feeds to much of my track, but there are a few areas that this would make some things easier for myself. FYI, I am using Ross and Gargraves track. Any help is appreciated.
Replies sorted oldest to newest
If you are not good at soldering, Gargraves make track power clips that push in from the bottom of the track and are not as tacky looking as the big Lionel power clip-ons plus you can paint the exposed area of the Gargraves clip to conceal some of the metal look. I am not that good at soldering and secondly I don't have good ventilation to be soldering.
Either Gargraves or Ross Custom switches sells the track clips.
Lee Fritz
I use Ross track and use spade connectors pushed into the bottom of the rail. I bend the spade at a 90 degree angle so the track can sit flush.
Access to this requires an OGR Forum Supporting Membership
