Skip to main content

I have read that many use Tstat wire for accessories, and I would like to as well. Is there any concern using 18 gauge wire for PW accessories with motors like the 313, 364, 97, etc.? I know I wouldn't use that gauge for train power, but some of these accessories have sizeable motors. Is the wire at risk of overheating, especially if I get a short somewhere?

Original Post

Replies sorted oldest to newest

It depends on the size of your layout and the length of the wire.  The large postwar motors might need larger wire for the startup current.  If you protect your accessory circuits with PolySwitches you can try different amp ratings for the load.  My large accessories are fed with #16 wire.  The low load stuff is fed with thermostat wire, etc.  That Wire Sizes page shows uses for each size wire toward the end of the page.

Two of my operating accessory circuits have been raised from 3A (650-RUEF300) to 4A (650-UEF400) circuit protection.  With several people operating different accessories at once I had to up the rating.   The chain drive coaling tower and log loader together need the 4A.
For my Z-stuff switch machines circuit, I use 2 1/2 A 650-RUEF250.

Add Reply

Post

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
Link copied to your clipboard.
×
×