Skip to main content

Just wondering if anyone has tips for getting more out of my CC2 running on a conventional transformer.

* The main stack smokes pretty well but it never "chuffs".

* The whistle steam is barely noticeable.

* I have yet to see any "blowdown" steam.

* Swinging bell works great. 

Pennslvania 0-8-8-0 CC2 Steam Locomotive #8183 (lionel.com)

Thanks,

John

Last edited by John Lutz
Original Post

Replies sorted oldest to newest

Short answer is nothing more you can do other than get a command system

1. I assume when you say “chuff” you mean you never see individual pulses of smoke. Answer to that is most likely in a conventional environment you can’t go slow enough where you see that and still have enough voltage to even make smoke



2. It’s not impossible that the batting needs to be replaced for the whistle but again in conventional unless your running it at full voltage your not going to get a full amount of smoke. I’d put it in neutral and crank the voltage to 18V let it set then lay on the whistle if there’s no change then I’d start looking at batting.

3. Blowdown is ONLY available in a command environment

Add Reply

Post
This forum is sponsored by Lionel, LLC

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
Link copied to your clipboard.
×
×