Skip to main content

Replies sorted oldest to newest

can I use the controller to bring the 21 volts from the brick down to 18-19 before going into the TIU? Also what channel would be used in the TIU, variable or fixed ?

As I said above:

Under DCS, use an MTH #50-1017 TIU/Barrel Jack Connector to connect to a TIU variable channel, and use the variable channel to adjust the voltage.

In this case, you would not use the Z-Controller.

 

Add Reply

Post
The DCS Forum is sponsored by

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
Link copied to your clipboard.
×
×