Skip to main content

Hi GUYZ,

  I have a Weaver G1098LP O Gauge BRASS Reading G1 4-6-2 Steam Loco w/ Tender TMCC #109.  This engine runs real good but I want to get slower starts and maintain speeds around long curves and inclines.  The question I have is will ERR CC- M work in this engine?  Is there any problems doing this upgrade?   Thanks for your time.

Original Post

Replies sorted oldest to newest

George, you should be able to swap out the TMCC driver ( DCDR ) for the ERR Cruise M, ….you’ll have to add a wire for the serial data to control the M, but it’s not difficult at all,…..first things first would be to take a picture of the existing set up and let us have a looksie around with you,…you may have to add a serial buffer, depending on how much the data stream gets robbed by the M,….

Pat

Add Reply

Post
OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
330-757-3020

www.ogaugerr.com
×
×
×
×
Link copied to your clipboard.
×
×