Skip to main content

Replies sorted oldest to newest

trnluvr posted:

https://youtu.be/kIzgwKxF5f8

I don't know if this will help your problem but can't hurt to try.

Doug

I understand doing a factory reset but I have never seen that sequence in the video before - what with going into CAB1 mode and all. It does not mention having to reset the engine ID afterwards, which I assume is required. Will have to excavate a Legacy manual and see if this process is referred to there.

gunrunnerjohn posted:

There's nothing that I can imagine that can fix that other than a physical repair.  The Legacy RS-Lite board simply isn't capable of emitting those sounds in normal operation, something is broken.

That’s too bad. It is a favorite of mine.  All sounds work but that noise is annoying. 

 

On the plus side, DCS never worked right on my layout.  But reading here on the forum I think I finally know why.  I did not pull the center pin on each powered block. I tried dcs on my expansion, which is separated and it works.  If I want to go back and pull pins I guess I could make the whole layout work. 

Add Reply

Post

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
Link copied to your clipboard.
×
×