Skip to main content

The above mentioned smoke unit has 3 input wiress. My understanding is the outside 2 wires are for the hot and the middle wire is the ground. Does it make a difference which hot wire is connected to the feature output of an ERR Cruise Commander?  I am using a ERR "Puff and Chuff" module I've had for several years to sync the smoke and chuff.

JPThut

Original Post

Replies sorted oldest to newest

On the 3 pin feed connector to the 8057-200, the outside 2 pins should be jumpered together at the connector. One side is hot to the heater and the other side is feed for the fan motor 5 volt dc circuit. The middle pin is chassis ground. So just one hot wire to the ERR P & C. You can BTW jumper the 2 outside pins on the solder side (top) of the SMU circuit board if that's easier.

Rod

Add Reply

Post

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
Link copied to your clipboard.
×
×