I was testing an accessory and shorted the Z4000 10V Fixed output by touching the alligator clip test leads I had connected to it together. I heard a little pop as if it was a circuit breaker or fuse blown within the Z4000.
Shut and started the Z4000. I get 0 volts on it. Everything else is working.
Can I fix this?
Replies sorted oldest to newest
Did you reset the breaker on the back?
Bingo!
Took a closer look and it was on the side towards the back. We're all good.
Big thanks!
Glad to hear it was an easy solution.
I have a new problem: a short on fixed 14v, but neither breaker trips.
if I connect wires to 10v fixed the 4 Amp breaker trips and can reset it. Other outputs on transformer for track voltage are good.
the 14v fixed is 0 volts with nothing connected.
Any thoughts on how to restore power to it?
There are 4 breakers Two on each side
Yeah, I noticed that right after I posted. 😖
All good.
Access to this requires an OGR Forum Supporting Membership
