Skip to main content

Reply to "Insulated rail signal works properly when track power is not applied."

OPTION B – If the optical sensor is covered with black tape, then the input
(YELLOW) wire can be used to control the sensor. Connecting the input wire
to an isolated rail will cause the sensor to change its two outputs and operate
a typical LED signal.

Did you remember to cover the sensor with black elect tape? - this is my guess

Did you connect the yellow wire to the track?

Joe

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
×