3D Printed Coupler Pads for Atlas RS-1

In case anyone was wondering, these have been redesigned for a more prototypical look.

Ok, here's the final design on the RS-1. 

I added a few tricks. 

Here's what this past version looked like, looked great... didn't work so well. 

The new ones are just right. 

Looks really good.  Dropped my orders earlier today. I take it I am the first for the RS11s? or do you have a pic with it installed. Also why the two different type of spacers?

Doug,

The two different RS-11 coupler mounts have some subtle detail differences, with the open space removed on the "Experimental" one...

They should fit into the opening, but I haven't gotten my order yet to test them. I'm going for a minimalist approach. 

Thanks,

Mario

Mario

         I was talking about the spacers. So that means I am part of the experiment too? 

        6x Lionel O Scale RS-11 Coupler Mount (EXPERIMENTAL) in Black Strong & Flexible

• 4x Lionel O Scale RS-11 Pilot Spacer *EXPERIMENTAL* 2 in Black Strong & Flexible
• 4x Lionel O Scale RS-11 Pilot Spacer *EXPERIMENTAL* 3 in Black Strong & Flexible

Doug

Those  are a little different. Well, a lot different. 

 These, I designed them to slide on the end of the frame, because of the big gap between the frame and the shell. 

these represent the back side, with a slot for the frame. The square hole is for the front railing screw. 

So I played it Safe and ordered both. Either way I glad to inadvertently be helping validate the design.  In the next couple of days I take the measurements for the MTH GP pilots and depth of spacer so you can offer an product. Same as for the SD 24 if you want. The redesigned GP 30 fits without modification but still need some adjustments.

My trial run of the RS-11 experimental designs should be here tomorrow. 

Long hood