Building new layout using GarGraves track.using DCS system. How do I power the track? How do I solder? What works best? Need suggestions. Where do I go for step by step soldering ? Thx.
Original Post
Replies sorted oldest to newest
Originally Posted by Arthur P. Bloom:
These are used to connect a wire to the bottom of the GG rail (in the slot.) No soldering necessary. Crimp a short length of wire to the tab, insert the tab into the rail, and pass the wire down through the table where it is attached to the main bus wire.
Yes, you need to connect the two outer rails for the best reliability. The exception is where you want to use a short section of rail to provided occupancy detection for a signal or a control panel pilot lamp.
Or, use the right angle "flag" versions if you can't go down:
