Skip to main content

Closed3 replies

Do Trainmaster Command Bases wear out?

EE Eric EOGR Forum Member

I inherited a TMCC trainmaster command base and Cab-1 remote.  They had sat for years, and I recently got my own layout up and running.  I had to buy another command base to get everything to work with my conventional, TMCC & Legacy trains.  The command base was not responding like the power master does. (The red light never blinked when addressing it).  I had contacted Lionel and they offered a lot of help.  Is there anything inside the command base that can wear out or be repaired?  I am not an electronics guru.  I was just wondering if the non-working command base could be fixed or if it would be worth anything to anyone? (I obviously don't need two of them).  Lionel had mentioned that it would cost more for them to look at it than for me to buy another one.  Any feedback would be appreciated.

Original Post

Replies sorted oldest to newest

FM Former Member
Originally Posted by Eric E:

I inherited a TMCC trainmaster command base and Cab-1 remote.  They had sat for years, and I recently got my own layout up and running.  I had to buy another command base to get everything to work with my conventional, TMCC & Legacy trains.  The command base was not responding like the power master does. (The red light never blinked when addressing it).  I had contacted Lionel and they offered a lot of help.  Is there anything inside the command base that can wear out or be repaired?  I am not an electronics guru.  I was just wondering if the non-working command base could be fixed or if it would be worth anything to anyone? (I obviously don't need two of them).  Lionel had mentioned that it would cost more for them to look at it than for me to buy another one.  Any feedback would be appreciated.

I had a Powermaster that when addressed the red light did not blink but the unit itself functioned. Took the shell off and found out that the wire going to the light bulb was disconnected. Seems when the unit was manufactured they used hot melt glue to attach the wire and it was never done properly.

 

Removed the glue and connected the wire and then the light flickered when the PM was addressed. Not sure if that is your problem but you might check to see if the unit does in fact work but the light just does not indicate that.

Views: 763
Post

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

Membership Required

We're sorry. You must be signed in to continue. Sign In or Register
×
Are you sure you want to remove from your Block List?
×
Loading...
×
When you block a person, they can no longer invite you to a private message or post to your profile wall. Replies and comments they make will be collapsed/hidden by default. Finally, you'll never receive email notifications about content they create or likes they designate for your content.
Note: if you proceed, you will no longer be following .
×
Link copied to your clipboard.
×

Access to this requires an OGR Forum Supporting Membership

OGR Forum Supporting Membership

Help support this forum with an OGR Forum Supporting Membership.
You will be able to watch the videos in the INSTRUCTIONAL VIDEO FORUM!
A one-year OGR Forum Supporting Membership is only $12 per year, so sign up now!


    OR     


Access the ALL the OGR VIDEO FORUMS AND  over 300 back issues of OGR
with a DIGITAL SUBSCRIPTION!



$12.00 per 12 Months (plus tax if applicable)
×