I am repainting this ex-Circus RS3 into a Jersey Central scheme and wanted to put the dual-beam Pyle National headlights in each end to make it more realistic. I have the Pyle National castings already but need advice on replacing the existing single bulbs at each end to dual bulbs. I could not find anything about this in a search here. Any advice would be appreciated, thanks.
Replies sorted oldest to newest
I used 3mm warm white 12v pre wired led's on my engine, purrfect fit...
You could use MTH 6 volt bulbs or LEDs. I would also recommend 3mm LEDs as they don't get hot. Just have to watch the polarity or they won't light. I like the super bright warm white ones.
( Add around 300 ohm resistors in the line too for PS2. Lower number makes the lights even brighter.)
You should post this in the DCS forum for more help from the techs.
Access to this requires an OGR Forum Supporting Membership
