Skip to main content

I have two MTH engines that are PS-1 and because I run in DCS they hardly ever run.  If they are run, only for a few minutes and then put back on the shelf.  I assume the installation cost would be well over$200 to $300.  I paid just over $300 for the engines.   As for myself, if I were to buy a used PS-1 engine.  I would pay, half of that or less.  I think most would too.  What's your thought?

If I have the upgrades done.  Has anybody had any problems with the up grade?

I would like to keep the replaced PS-1 Boards.  Is that possible? Storage is the concern.

Original Post

Replies sorted oldest to newest

Originally Posted by Missabe:

What is the cost?  

 

depending on whether you are A MTHRRC Club Member

Member Approximately 150 to 180 Non Member Around 200 to just a little over

 

Estimated S/H cost? Not sure depends on where you are in the world

 

 

Is it possible to keep the PS-1 Board?

 

Yes it is possible to keep the PS-1 Board just make sure you keep it intact as possible and do a notation of which wires went where to use in another engine or to put back into the engine you took it out of.  The PS-2 is a complete set up has every thing in it to do the conversion.  Unless it is a Steam Engine, If Steam engine you have to modify the Smoke unit board according to instructions that is in the PS-2 Kit

 

Missabe Go to the MTH Protosound 2 Webssite and download the instructions for the PS2 Kit you need and read through them.

Good Luck

Originally Posted by Missabe:

Joe, that great idea.

I had to replace a PS-2 board when I forget to shut the power off when checking for a smoke unit problem.  $300 lesson learned.

Maybe a technician  would be interested.


Like I said I do them.  My e-mail is in my profile.  You can send me an e-mail.   G

Post
The DCS Forum is sponsored by

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
Link copied to your clipboard.
×
×