I have an SC-2 which I have cut the com trace loose on position #1 just as I have done on 3 other SC-2s, but on this one there seems to be some power still applied to the thru and out wires (red and green). When I switch the switch with the controller, I can still cause the switch to click even though it is already in that position. When I use the cab2 to activate the switch, it chatters while the relay is in play in the SC-2. AND the micro switches are working properly in the switch. If I disconnect power to the SC-2 or disconnect the switch from the SC-2, the switch works normally.
There is no continuity across the cut I made.
There is nothing unusual that I measure voltage wise from the other switches terminals either in position #1 on other SC-2s or on other switch positions on the odd SC-2.
Power to the SC-2s is in phase with the switch power.
Anybody have any idea about the SC-2 which could cause this?
