Good afternoon friends;
I am requesting pictures of how you have your bus style wiring starting from the back of a transformer ( preferably Z-4000 ). to a terminal strip.
I had another thread going ( bus wire and feeder ) but sadly, I cannot get it. I lack the understanding of how this works.
I have run my own succesful business for over 20 years, but can't figure out how to wire up two loops of track...
That is where I am stuck.
Can anyone post pictures of there setup that I am looking for? I want to keep it simple, but don't want to do this twice.
I also have accessories to add to the layout, the Z can be wired for both fixed and variable for that right? Or should I use
Breakdown of my layout. 10.5 x 19 around the wall layout with a drop down at one end.
I have two main loops - O84 and O72 with an inside passing loop of O60 with one siding coming off that. I have as a transformer the Z-4000.
I will be using min. TMCC and a few of the new Lion Chief Thomas sets. So the BUS style wiring is what I am looking for.
I have watched the Lionel video on wiring a few times and it shows him using a 'common wire' and then one wire each for each loop of track.
It does not however show where and what those wires are attached to or how they are attached to the transformer.
Hopefully the pictures will help.
Thank you,
Bryan
