Cab 1L conventional mode issue

See page 13 of your TPC's Owner's Manual, "Operating the TPC Unit in the conventional (non-Command) environment"

Cheers,
Rudy

Thanks Rudy, will do, Jerry

Jerry, I run conventional with Cab 1 L with no problems. Just wondering, did Jerry's suggestion help?

Ray

Put your TPC into conventional mode and make sure when you do that, PRESS THE SET BUTTON. Otherwise, when you turn the power off, your TPC will revert back to command mode (it is like it's default mode).

In conventional, you address the TPC and dial up the power with your cab1L. Or press 8 for 30% power or 9 for 100% power to the track it is hooked up to.

1. Thanks all. I just found out that if you read the instructions like you guys suggested you can probably get things working fine as I finally did. I thought I was in conventional mode and I guess I was but I didn't set it right. Now that I said it to instructions everything works fine hand the units were good and everything else.

I am doing about 200 things at once on the layout and probably making matters more confusing for myself but thanks to you guys you get me out of trouble.

Much thanks for your help, Jerry