Ceiling train

Very impressive, looks great!  It's already all landscaped.

Thanks John,

The fella that I’m helping with this project wants as much outer landscaping as possible.  He has spent a copious amount of cash on this project so far.  I think he bought every tree that Woodland Scenics had in inventory.  The space up there is very tight so I’ll do the best that I can.  Thanks for the compliment!

Blake

You did a very nice job. Well finished. 

@DMASSO posted:

You did a very nice job. Well finished. 

Thanks DMASSO,

A work in progress but hope to finish before the end of October.  I’ll post a video after it’s completed.

Blake

Looking great. I have a 12' by 9 ' layout in my basement but I have always thought about a ceiling setup in my office (room is approximately 10' by 13' with 8' ceilings). What do you use with boarding around the ceiling? Custom made woodwork? I have been thinking of plexi-glass so I can see the trains better.  The scenery looks great.

JohnF

@John F posted:

Looking great. I have a 12' by 9 ' layout in my basement but I have always thought about a ceiling setup in my office (room is approximately 10' by 13' with 8' ceilings). What do you use with boarding around the ceiling? Custom made woodwork? I have been thinking of plexi-glass so I can see the trains better.  The scenery looks great.

 

JohnF

Hey JohnF,

The boards are stair step boards.  It was used because it already had the bullnose cut thereby giving it a better appearance than plain shelving board.  The corners were cut from 1” plastic vinyl sheets.  The sheets came in 4x8.  I got two corners out of one sheet.  Only thing I had to use the router on was those corners.  The shelves and corners are hung as a floating shelf so you wouldn’t see and shelf supports.  It was dressed up with some crown molding and all is painted.  Plexiglass is good but how would you conceal all the wires if you had lights and buildings?  

Blake

Beautiful job, Blake!!  The shelves, moulding, lighting, scenery, and ou yes the trains all look great!!!

@Mark Boyce posted:

Beautiful job, Blake!!  The shelves, moulding, lighting, scenery, and ou yes the trains all look great!!!

Thanks Mark!

There is a whole lot more to do on this experiment.

Blake

Years ago there was a casino in Laughlin NV that had many LGB trains on plexiglass hanging above gaming tables. Very clean look and enjoyable.

Added: There was no scenery and the power wires were inside the poles the plexiglass hung on. 

Nice Job

Wow! Wow!Wow! Fantastic job Blake. It's really beautiful with all the nice sceneries and decorations. 

@Hent05 posted:

Wow! Wow!Wow! Fantastic job Blake. It's really beautiful with all the nice sceneries and decorations. 

Thank you Hent05!

Its a work in progress.  I hope its at least satisfactory when I’m finished.

Blake

Blake:

I'm contemplating a ceiling route in my L-shaped train room, which is located in an addition to our house.  My layout platforms are an "echo" of that L-shaped room.  It's limited to Lionel tubular O42 curves and switches due to the dimensions of the room, but I want to run trains in my collection that require O72 curvatures; they are now on static display as "shelf queens."

I've done some pre-designing with ANYRAIL software and created a track plan with O72 Lionel FasTrack and Command Control switches, but shelf construction and installation of a "Nosebleed Route" would be a challenge; perhaps a nightmare!

My layout is already in place, but ...
*  There's limited aisle space around the perimeter of the layout, so installing shelves above that area would be difficult and would require special scaffolding for access to the ceiling. I don't want to remove the layout from the room - it's in five sections. Photos are attached.
*  There's a ceiling beam at the angle of the "L;"  cutting two tunnel portals through it might be hazardous.
*  Construction would likely be messy with sawdust, drill shavings, and stuff falling on the layout. I could cover it with drop cloths and hope that no heavy objects would fall on the layout below. 
*  My workshop is adjacent to the L-shaped train room. I'd like to run a ceiling route through that room too, but those walls are brick.  Jackhammers?
*  Fortunately, electricity is accessible above the suspended ceiling.
*  Also fortunately, the trains I want to run on the ceiling route are TMCC/Legacy equipped, so they would respond to commands from my CAB-1.  I'd upgrade the control system to Legacy control gear with a CAB-1L. The draft track plan calls for 10 switches, so Command Control of switches would avoid lots of wiring.
*  I'd have to create a method to re-rail a train up there.  Wear a rock-climbing harness attached to a skyhook?

Confessions ...

I didn't think far enough ahead. With a few O72-dependent trains on hand (and another O72 train set recently added to my collection), I should have built the ceiling route first and then installed the layout beneath it afterwards.  20/20 hindsight is always right.

I foresee the need for a guard rail along the entire ceiling route -- to keep a derailed train from falling on the layout below or to the (concrete) floor.d

Kudos with envy ...

Your ceiling route looks "clean" with no "inverted U" ceiling-mounted supports or brackets underneath. Very cool. Is the shelf totally supported by the crown moldings?  Buildings, landscaping, and trackside signals add interest. I love the telephone poles for added realism.

Comments from other hobbyists who solved ceiling layout problems are welcome. 

Mike M.    LCCA 12394
mottlerm@gmail.com

Hey Mike,

The shelving is called floating shelves.  They are anchored to the studs with bolts.  If you’re curious to how they’re built just go and do a YouTube search for installing floating shelves.

Thanks,

Blake

Well done!  Good use of materials and techniques, and nice craftsmanship.

Blake, the ceiling layout looks awesome with our PTF DESIGNS building flats!  Thanks for sharing!

@Nick PghTrainFanatic posted:

Blake, the ceiling layout looks awesome with our PTF DESIGNS building flats!  Thanks for sharing!

Hey Nick,

just wait til it’s all finished my friend!  The way he’s spending cash,  it’s going to be spectacular,  I hope.

Blake

So I just finished installing all the neon signs and crossing signals.  To get rid of the flat look,  I will be attempting to use the woodland scenics products around the interior portion of the layout.  This is my first time at doing this so don’t laugh at it too much, however, I can accept constructive criticism.  LOL 

Laugh???  You did an absolutely super job, Blake!  Everything about it is wonderful!!