Skip to main content

I just purchased a remote command control switch. There were several hitches even in the set-up.  First of all, it took a while for the beacon light to start blinking after I pushed the black button on the track.  Then, after I programed in the number and pushed the set button on the remote, it took a while for the light to stop blinking....  Then when I started using the remote, more often than not, the track switch did not respond (sometimes it did, and sometimes it did not).  The switch works well if I use the connected switch lever.

    Is this something than can be fixed, or is the switch just a lemon?

Original Post

Replies sorted oldest to newest

Add Reply

Post
OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
330-757-3020

www.ogaugerr.com
×
×
×
×
Link copied to your clipboard.
×
×