Happy Holidays to all and to all a good train day. Replaced thumb wheel in DCS remote now down is up, thought I was maybe little dyslexic might work better.
Replies sorted oldest to newest
There are two wires that need to be swapped, apparently the color codes aren't consistent. When I take one out, I note which connection on the thumbwheel goes to which main board connection and ignore the wire colors.
Yep, but some of them had the wrong colors for the wires.
Do you mean no red, green, or yellow?
I believe they were in the wrong order. I can't find the post about it, maybe @GGG remembers the details.
That's what the bulletin described. The one I took out was not the same order, so the factory switched a couple wires. The thumbwheel ended up working the right way with the new instructions.
Thanks John, I knew there was a switch, but I haven't been bit by it yet.
I hooked it up like the diagram in the post what is the new order according to the bulletin ?
Hi, you just roll the outer wires on the wheel, and it will work perfectly I remember when the replacements came out!
@Alan Mancus posted:
Hi, you just roll the outer wires on the wheel,
It's not a spool.
So switch the green and the red