Skip to main content

2 replies

F3 SantaFe Warbonnet Legacy F3 Powered B unit

BC Bobby CoxOGR Forum Member

Purchased Lionel Powered F3 Legacy B Unit (6-34579) and AA set (6-34573) at York week before last. I have never had a Legacy Powered B unit.  I have assigned the Powered A unit and the Powered B Unit individual I'd #'s. They are running independently of one another with the Cab 2 controller but when I hook them up together they are not in sinc. Do you sinc them by creating a lash - up? I have ever done this but may be able to with owners manual. Manual says #1 to create a lash-up address the train # you wish to create. Not sure what this means. Do you press TR then just make up a number for that particular lash-up (train I'd #) then press info followed by pressing BUILD then enter first engine#,etc.?

Thanks for your help, Bobby!

Original Post

Replies sorted oldest to newest

D&H 65D&H 65OGR Forum Member SUPPORTING MEMBER

What you wrote in your initial post appears to be correct for building a "Train". If you need further info, it is included in the owners manual.

One statement you made brings up a caveat; - you say they are not in sync when running separately. Any Legacy diesels should run very close by themselves. You should be aware that the production run of F units your diesels came from were plagued with over-sized traction tires that rub on the side-frame brake shoes. Please check your units before running too much to be sure they are not rubbing as it will affect their smooth running capabilities. MTH tires are a good replacement for these tires if you find they are rubbing.

B BobbyDOGR Forum Member DIGITAL SUBSCRIBER
Bobby Cox posted:

Purchased Lionel Powered F3 Legacy B Unit (6-34579) and AA set (6-34573) at York week before last. I have never had a Legacy Powered B unit.  I have assigned the Powered A unit and the Powered B Unit individual I'd #'s. They are running independently of one another with the Cab 2 controller but when I hook them up together they are not in sinc.

Sounds like you have assigned the A unit Engine #5, and the B unit Engine #6 and they do not move in sync as when they were both Engine #1 correct?  If so they are not hooked together (aka "lash-up") in the remote as a train #, say TR#7, and they won't run together.

If you are saying they are in as a "TR" train and run at different speeds, that's another issue.

Last edited by BobbyD

Add Reply

Views: 535
Post

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

Membership Required

We're sorry. You must be signed in to continue. Sign In or Register
×
Are you sure you want to remove from your Block List?
×
Loading...
×
When you block a person, they can no longer invite you to a private message or post to your profile wall. Replies and comments they make will be collapsed/hidden by default. Finally, you'll never receive email notifications about content they create or likes they designate for your content.
Note: if you proceed, you will no longer be following .
×
Link copied to your clipboard.
×

Access to this requires an OGR Forum Supporting Membership

OGR Forum Supporting Membership

Help support this forum with an OGR Forum Supporting Membership.
You will be able to watch the videos in the INSTRUCTIONAL VIDEO FORUM!
A one-year OGR Forum Supporting Membership is only $12 per year, so sign up now!


    OR     


Access the ALL the OGR VIDEO FORUMS AND  over 300 back issues of OGR
with a DIGITAL SUBSCRIPTION!



$12.00 per 12 Months (plus tax if applicable)
×