Skip to main content

I am having a problem with a 060 fastrack remote  (Command Control) switch. There is no problem when I switch it from straight to the curved section.  It is when I want to switch it from the curved section to the straight.  If I start flipping the switch controller from the straight to the curve and back rapidly the switch works fine, but if I wait a second while it is on the curve, it will not switch back using the controller. I have not tried to run it via Command Control.  I can move it back manually and it will work again until I keep it on the curved section.  Where should I start looking for the problem?

Original Post

Add Reply

Post

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
Link copied to your clipboard.
×
×