I accidentally programed the switch motor into DCS mode, and now I can't get it back into TMCC mode. Every time I do the "wait 2 seconds when the green light is on and the red light is blinking then release" the switch motor is still in DCS mode when I turn it off and back on again.
Thoughts/ suggestions?
Replies sorted oldest to newest
Right from Dennis at Z-Stuff, worked for me. If the green light is lighted after the initialization, you have to press the button on the switch machine momentarily to get the red light lighted, then follow the remainder of the instructions.
If the switch machine has both RED and GREEN "ON" together for the first two seconds at power up. If this is the case, then starting with the RED LED lighted, press and hold the button on top of the DZ-2500 until the RED and GREEN lights flash alternately. As soon as they do, release the push button. Then, turn off power. When power is turned on again everything should be fine.
@gunrunnerjohn posted:Right from Dennis at Z-Stuff, worked for me. If the green light is lighted after the initialization, you have to press the button on the switch machine momentarily to get the red light lighted, then follow the remainder of the instructions.
If the switch machine has both RED and GREEN "ON" together for the first two seconds at power up. If this is the case, then starting with the RED LED lighted, press and hold the button on top of the DZ-2500 until the RED and GREEN lights flash alternately. As soon as they do, release the push button. Then, turn off power. When power is turned on again everything should be fine.
Thanks, John! That did the trick!
Greg
Great, love success stories. Note that it's very specific how to get into the setup mode again, that threw me a couple of times before I realized I had to follow the indications exactly. 
Access to this requires an OGR Forum Supporting Membership
