Skip to main content

I am a complete Legacy noob, but have used MTH DCS alot.

My upper level is 100% isolated conventional right now, with 1 TMCC engine and 1 Legacy engine.

I connected the power and grounding wires from the base and the transformer per the manual (horrible) and the remote is charging.

The set came with version 1.2 blue modules, but I also have unopened 1.3 blue modules another forum member gave me.

I do not see anywhere in the manual on how to upgrade from whatever version is currently loaded to 1.3.

Do I load 1.2 first, and then 1.3?

Or do I just jump straight to 1.3?

Any help is appreciated.

 

Original Post

Replies sorted oldest to newest

Originally Posted by chipset:

 

I connected the power and grounding wires from the base and the transformer per the manual (horrible) and the remote is charging.

 

 

Just to be sure, the base should be plugged into the wall, and one wire from the base gets attached to a track common on your layout. It could be a common at the track or at the transformer it doesn't matter.

 

There may be an issue with the base charging and or batteries on your early 1.2 legacy set,if there is you can substitute with disposable batteries.

 

I waited for version 1.4 in hopes these issues were resolved.

 

I'm not trying to scare you, these improvements are not unlike MTH inproving the TIU with newer "REVs"

 

Lionel has been very good about doing any necessary repairs on the Legacy command sets Mike Reagan has stated that (obviously) legacy locos aren't much good if they do not support the system.

 

Should you need to send it in to Lionel, it can all be done via email, its fast and easy.

 

Martye is far more knowledgeable on Legacy than I, maybe he will chime in with more details.

Argh, both charging lights went solid red, which according to the manual means it got too hot.

The remote won't even power up...hopefully because there is not enough charge and not that it melted down or something.

I am going to install disposable batteries and hopefully remember to flick the switch on the base!

I will let you know if the remote works now.

FWIW you need to hold the power button down for a couple of seconds until it turns on, same when shutting it off.

 

Theres a safety built into the base, it monitors the heat if its too warm it automatically shuts down the charging. The issue is that the base components for running the trains warm a bit, then the charger and batteries warm and compound the problem.

 

 Most folks put a piece of tape over the charging terminals when not using it to elimate any risk of the batterries discharging into the base.

Post

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
Link copied to your clipboard.
×
×